[Ntop] sFlow not working!

[Chris Moore]

That should do it for config.

If you do a "show sflow" do you see samples being collected and being
exported?

-----Original Message-----
From: ntop-bounces at unipi.it [mailto:ntop-bounces at unipi.it] On Behalf Of
gmourani at privalodc.com
Sent: Tuesday, March 29, 2005 11:05 AM
To: ntop at Unipi.IT
Cc: ntop at Unipi.IT
Subject: RE: [Ntop] sFlow not working!

Here are the command I've used to configure the network foundry switch:
sflow enable
sflow agent-ip 172.16.2.251
sflow polling-interval 60
sflow destination 172.16.1.215
sflow forwarding # on each interface

> A good place to start is to just monitor the interface you should be 
> seeing the sFlow packets come in on and make sure you see the sFlow 
> packets themselves come in. If not, I can probably help with your 
> Foundry config.
>
> C


**********************************************************************
Confidential/Proprietary Note

The information in this email is confidential and may be legally privileged.  Access to this email by anyone other than the intended addressee is unauthorized.  If you are not the intended recipient of this message, any review, disclosure, copying, distribution, retention, or any action taken or omitted to be taken in reliance on it is prohibited and may be unlawful.  If you are not the intended recipient, please reply to or forward a copy of this message to the sender and delete the message, any attachments, and any copies thereof from your system.  Thank you. 
Guardian Mortgage Documents, Inc.
225 Union Boulevard, Suite 200
Lakewood, CO 80228.
**********************************************************************